Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in Paradise?
Chimney liner installation in Paradise typically costs $2,400 to $6,800 for a full stainless liner, and a partial chimney rebuild usually runs $3,200 to $9,500 depending on how much masonry is damaged. A crown rebuild alone is far smaller, often $650 to $1,800. The written estimate sets the final price, and we give that estimate free so you know the number before anyone touches the roof.
Those ranges are wide because liner and rebuild work is never one job. A cracked crown is a morning of work. A rebuild above the roofline that pulls out damaged brick and ties in new masonry is a different project with scaffolding and material staging. We price each one on its own scope, then put it in writing. Our technicians have up to 12 years of experience reading exactly how far a chimney has failed and where the repair should stop.
Key Takeaways
- Full stainless liner installs in Paradise run roughly $2,400 to $6,800.
- A partial rebuild is typically $3,200 to $9,500; a crown rebuild $650 to $1,800.
- Liner choice matters more than anything else on cost. We install DuraFlex liner systems, Gelco and Olympia Chimney components, and use HeatShield for resurfacing.
- Desert heat, dry cycles and wind-driven dust wear masonry year after year in the Las Vegas Valley.
- Estimates are free, and the written estimate is the price. Call (844) 314-6144. We answer 24/7.
Chimney Liner & Rebuild Cost Breakdown (2026)
Here’s how the work breaks out across the Paradise market. These are typical ranges for each line item, not a quote for your chimney. Your chimney’s height, the flue size, the appliance it serves and the condition of the masonry all move the number.
| Scope of work | Typical range | What’s included |
|---|---|---|
| Stainless steel liner, full length | $2,400 – $6,800 | Liner, insulation and fittings sized to the flue, installed and capped |
| Liner for a short single-story flue | $1,900 – $3,200 | Shorter run, standard appliance connection |
| Liner for a tall or offset flue | $4,500 – $6,800 | Longer runs and offset offsets that need flexible liner segments |
| Crown rebuild | $650 – $1,800 | Old crown removed, new crown formed and cured |
| Partial rebuild above the roofline | $3,200 – $9,500 | Damaged brick removed and replaced, mortar joints rebuilt, cap reset |
| HeatShield flue resurfacing | $1,800 – $4,200 | Flue cleaned, joints and cracks sealed with the resurfacing system |
| Crown and cap repair | $300 – $950 | Sealing cracks, resetting or replacing the cap |
| Firebox repair | $900 – $3,400 | Rebuilding damaged firebox brick and joints |
The single biggest cost driver is the liner itself. Stainless liner priced by the linear foot adds up fast on a two-story flue, and an offset (a jog in the flue path) takes more time and more material. Insulation to keep the liner warm matters just as much. On the rebuild side, what pushes the number up is access: a chimney that’s easy to reach from the roof with room to stage material is cheaper to rebuild than one tucked against a wall or behind a steep pitch. Cracks that stop at the crown stay in the crown line. Cracks that run down the brick mean the rebuild scope grows. When we quote, we explain which of those lines applies and why, so the estimate isn’t a mystery number.
What Affects Chimney Liner & Rebuild Pricing in Paradise
Paradise homes have their own mix of conditions, and those conditions show up in the price. Here’s what moves it:
- Liner material and brand. The liner is the largest line item on most jobs. We install DuraFlex liner systems, and we fit Gelco, Olympia Chimney, Famco and Copperfield components. Brand availability and material grade each shift the total, which is why we price the actual product going into your flue rather than a generic allowance.
- Flue height and offsets. A single-story flue is shorter and cheaper to line. A two-story flue with a bend in it takes more liner, more insulation and more installation time, so it lands near the top of the range.
- Damage below the roofline. This is the difference between a crown job and a rebuild. If the water damage reaches past the cap and crown and into the brickwork, we’re rebuilding masonry, not sealing it, and the price reflects that bigger scope.
- How the chimney sits on the roof. A chimney that’s easy to stand beside and stage material near is quicker to work on. One against a wall or under a steep pitch takes scaffolding and longer setup, and setup is part of the estimate.
- Desert heat and dry cycles. The Las Vegas Valley’s heat, intense sun and long dry stretches put masonry through constant expansion and contraction, and wind-driven dust works into mortar joints over the seasons. Cracked crowns and loose mortar are common repair findings in Paradise, and both get priced as they’re found.
- What the chimney serves. A wood-burning fireplace, a gas appliance and a wood stove each need correct flue sizing and the right liner for the job. A liner sized wrong for the appliance is money spent twice, so we confirm sizing before quoting.
If you want a sense of how your chimney fits into this, the broader chimney sweep paradise service picture covers cleaning and inspection first, which is how we find out what the liner and rebuild work actually needs. For homeowners across Paradise, that inspection-first approach is what keeps the estimate honest.
Chimney Rebuild vs. Liner Replacement: Which Do You Need?
A liner replacement fixes the flue. A rebuild fixes the masonry structure around it. They solve different problems, and sometimes a chimney needs both. A full liner replacement is the right call when the flue interior is cracked, pitted or oversized for the appliance. A rebuild is the right call when the brickwork above the roofline is spalling, the mortar joints have crumbled or the crown has failed badly enough that water is getting in.
Here’s the practical split:
- Liner replacement alone: the brick looks solid from the roof, the crown is intact, but the flue interior is failing. This is the common case.
- HeatShield resurfacing as a middle route: when the flue has cracks and gaps but isn’t collapsing, HeatShield resurfacing can seal and smooth the flue without a full liner. It’s a middle-cost option on the right flue.
- Rebuild alone: the flue is sound but the masonry above the roofline is worn away. A rebuild brings the structure back without touching the flue.
- Both: a chimney with cracked brick and a cracked flue at the same time. When that happens we scope both, which is why we can handle multi-problem jobs without you sourcing two contractors.
Why an Inspection Comes Before Any Price
We can’t price a rebuild from a photo three houses away. The condition of the brick above the roofline, the state of the crown, and what’s inside the flue all determine which lines apply. A free estimate starts with looking, and the written estimate records what we found. It’s a small step that prevents paying for a rebuild you didn’t need or a liner on top of masonry that was about to fail.
What’s Involved in a Liner Installation and a Rebuild
Knowing the shape of the work keeps you from being surprised on the day. For a liner installation, we clean the flue first so the liner seats correctly, then size and fit the liner, add insulation and connect and cap it. A rebuild starts by removing damaged masonry, rebuilding the brickwork and joints, and resetting or replacing the crown and cap so water sheds away from the chimney instead of into it. Both jobs finish with a check of the whole system, from the firebox up to the cap and out through the flue.
A Safety Note on Chimney Repairs
Roof work and flue work are not a weekend DIY job. A chimney repair means being up at roof height, and a failed liner lets combustion gases – including carbon monoxide – move into the house instead of up and out. The liner and the flue are the parts that carry those gases away; a crack or gap in the wrong place is a hazard, not a nuisance. If your liner is suspect, don’t run the fireplace. Have a trained professional look at it. We can inspect and quote the liner and rebuild scope together, so you know both numbers before any work begins.
How to Save on Chimney Liner & Rebuild
The best savings come from catching the problem before it grows. A cracked crown that’s repaired for $300 to $950 in a crown-repair range won’t turn into a rebuild costing thousands if it’s caught early. Here’s what actually moves the price down:
- Fix the crown before it becomes a rebuild. Crown and cap repair is a small job. Once water gets past a failed crown, the damage reaches into the brickwork and the scope grows into rebuild territory.
- Inspect before the season. A cleaning and inspection shows the condition of the flue and masonry while there’s still time for a small repair rather than a big one. This is exactly what a routine chimney sweep in Paradise covers.
- Don’t replace a flue that can be resurfaced. If a HeatShield resurfacing is right for your flue, it can solve the problem for less than a full liner. We’ll tell you when that applies and when it doesn’t.
- Get more than one problem scoped at once. If your liner and masonry both need work, having one specialist scope the whole job keeps the project organized and avoids repeat setup costs.
- Use the right liner the first time. A liner sized wrong for the appliance gets replaced early. We size the flue to the appliance before quoting, so the liner we install is the one the system needs.
The number in the written estimate is the number you’ll pay, and getting that number costs nothing. Call (844) 314-6144 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
FAQs – Chimney Liner & Rebuild Cost
How much does chimney liner installation cost in Paradise?
Stainless liner installation in Paradise typically runs $2,400 to $6,800, with shorter single-story flues near $1,900 to $3,200 and tall or offset flues toward the top of the range. Liner choice, height and insulation drive the difference. Call (844) 314-6144 for an exact quote – estimates are free.
How much does a chimney rebuild cost in Paradise?
A partial rebuild above the roofline usually runs $3,200 to $9,500, while a crown rebuild alone is typically $650 to $1,800. The scope is set by how far the damage runs into the brickwork. Call (844) 314-6144 for a free estimate on your chimney’s actual condition.
Is it cheaper to repair or replace a chimney liner?
When the damage is limited to cracks and gaps in the flue, HeatShield resurfacing can cost less than a full liner – often $1,800 to $4,200 versus $2,400 to $6,800 for a liner. When the flue is structurally failing, a new liner is the right and cheaper long-term fix. A free inspection tells you which applies. Call (844) 314-6144.
Can you do a chimney liner and rebuild at the same time?
Yes. When a chimney needs both a liner and masonry work, we scope the whole job as one project, so you don’t have to source two contractors. The combined estimate covers both lines, and the pricing follows the same 2026 line items on this page. Call (844) 314-6144 to get both numbers together.
Can you come today?
Often yes. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday, so many Paradise homeowners get a free estimate on the same day they call. Call (844) 314-6144 to see the next opening. The estimate and the exact quote come at no charge.
Why Paradise Homeowners Call Chimney Sweep Paradise
Chimney liner and rebuild work is one half of what we do. We also handle chimney sweeping and dryer vent cleaning, so we look at the whole system instead of one part of it. The liner is our specialty – DuraFlex liner systems, Olympia Chimney and Gelco components, Famco caps, and HeatShield resurfacing when a flue can be sealed rather than lined. All of it is professional-grade material, not a generic substitute.
Why that matters on your estimate: a liner and rebuild job carries a real fire and carbon-monoxide hazard if it’s done with the wrong material. We quote the product going into your chimney, and we explain what it does. There’s no trade secret in the price, just the same materials chimney professionals use nationwide, priced honestly for the scope in front of us.
If you’ve noticed slow dryer cycles or lint buildup while we’re in the house, we can look at the dryer vent too. A dryer vent is a chimney in a lot of ways – it carries heat and lint out of the home, and a clogged one is a real fire risk. That’s the kind of thing that’s easy to catch when one specialist is already through the system with you.
Get a Free Chimney Liner & Rebuild Estimate in Paradise
You don’t need to guess what a liner or rebuild will cost. We look, we scope what actually needs doing, and we put the price in writing for free. Our technicians have up to 12 years of experience, and the number in that written estimate is the price that holds. Call (844) 314-6144. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. If you’ve got a failing crown that’s turning into a rebuild, or a flue with no liner and a winter coming, now is the time to get the number, not after the damage spreads.
Written by the team at Chimney Sweep Paradise.
Pricing reflects the Paradise market as of 2026. Chimney Sweep Paradise offers free estimates – call (844) 314-6144.
What Our Customers Say
"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
- Oscar Garcia"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
- Maurice Grant"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Marco Castillo